Interspace Industries TheatreCue 16 Way V4 System - 16 Outstations - Manual (Page 40)

Designed and created by:-
Built By
Dimmer option
The
intensity for all 16 channels to 100%.
The green Edit Channel buttons are not used.
There is no provision to set individual channels to
intensities lower than 100%.
If dimmer intensities other than 100% need to be saved to
one of the User files, do the following:
Save your initial configuration to the ShowTime file.
Exit the Editor. The
file will be loaded by the
Master Stations’ operating system to run the Cue Lights.
Press and hold the blue Dimmer button. Now press either
the Standby (increase) or Go (decrease) button on the
desired channel to adjust the dimmer intensity to that
required.
Any changes made are written to the
file.
Start the Editor.
The Editor starts with the
file already loaded.
This will also include the dimmer changes just made.
Save to one of the four User files.
Dimmers to 100% button resets the dimmer
ShowTime
ShowTime
ShowTime
Exit the Editor.
•
•
•
•
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Power
Cue Light
Options
Edit
Channel
Master
Options
Edit all
16 ch.
Cue Light & Master.
Page 1
Save
Exit
Open Master’s
Address
Group btns
linked
S/by flash
on Master S/by flash
on Outstn Standby
Latches
Dim on
ACK
Go
flickers
Go
times out
Go
flashes
Go
latches
Go & S/by
interlocked
Call lamp
enabled
Call lamp
flashes
ACK back-
light on
Beepers
enabled
Beep
on Go
Dimmers
to 100%
Yellow
Standby
Cue Light Outstation options
Installer
defaults
User 1 User 2 User 3 User 4
Show
Time
Factory
default red
Factory
default yel
Master Station Configuration Editor
2
1
1
•
40.
Multiple channels can be dimmed simultaneously by
assigning channels to one of the 2 Groups and then
using that Group’s Master Go and Standby buttons to
increase or decrease the dimmer intensities.
( This tip only applies when the Editor is not active)
Tip:
•
(continued)
Theatre Cue Light
Master QLM16i2 Mk4
www.interspaceind.com
Innovation by:-
Built By:-
2
Select
page