Interspace Industries TheatreCue 16 Way V4 System - 16 Outstations - Manual (Page 2)

Designed and created by:-
Built By
02.
Power.
36V DC 1.9A
Master Station’s front panel
Master Station’s rear panel
Cue Light Outstation
Quick Start Guide
Using a standard 3 pin XLR microphone cable , c
one or more Outstations to either XLR connector on the
Master Station’s rear panel.
Both XLRs on the Master Station can be used at the same
time.
Both Go and Standby lamps on the Master Station will
light dimmed once the Outstation has performed a lamp test.
Press a Standby button on the Master Station.
Standby lamps on the Master Station & Outstation
flash.
Press the Outstation’s Confirm button
The Standby lamps burn steadily.
Pressing the Confirm button when the Standby lamp is not
flashing will light the Call lamp
Press the Go button
The Go lamps light.
The Standby lamp goes out if it was on.
After 3 seconds the Go lamp flashes.
After a total of 15 seconds, the Go lamp turns itself off.
Trigger cues across multiple channels by the press of a
single master Group button
When an Outstation is unplugged, the Fault lamp
flashes.
Reset the Fault lamps by pressing both the red and blue
buttons on the Master Station.
onnect
Assign channels to Group A or B
2
5
4 3
10
5
3
4
6
8
7
9
10
3
3 7
9
4
4 8
6
1
3 7
•
•
•
•
•
•
•
1
2