Lingenfelter L650100206 PP C6 Z06 Corvette Air Intake Instructions v3.02 small - Manual (Page 9)

L650100206 PP C6 Z06 Corvette Air Intake Instructions v3.02.indd
1557 Winchester Road
Decatur, Indiana 46733
260 724 2552 phone
260 724 8761 fax
www.lingenfelter.com
Page 8 of 8
The following steps need to be done from underneath the vehicle:
• Replace the previously removed two factory Christmas tree fasteners retaining the shroud to the plastic side
panels.
• Install the lower air intake block off cover.
• Replace the five 7 mm head screws previously removed.
• Replace the three 10 mm head screws to secure the block off cover.
• Reinstall the left wheel extension housing and brake duct.
• You are now finished under the vehicle so you may lower the vehicle back down from the jack stands.
With the vehicle back on the ground, you now need to perform the following steps:
•
Check for hood clearance issues, if you need to readjust, loosen clamps and push the air bridge assembly
toward the throttle body while tightening the clamps.
• Reconnect the outside air temperature connector and the hood light connector.
• Reconnect the battery ground cable.
•
Reprogram your engine control module (ECM) using the supplied Lingenfelter Power Programmer (LN30203)
• Follow the instructions found on the CDROM included with the programmer.
• Replace the oil lost during the removal of the oil cooler.
• Start the vehicle and check for oil leaks at the oil cooler lines.
• Check your oil level. Be sure to follow the manufacturer’s recommendations for checking the oil level on the
Z06 Corvette. The dry-sump oil system on the LS7 engine has a different oil level checking procedure than
other Corvettes.
Congratulations - you have completed the installation.
WARNING: CAUTION SHOULD BE USED WHEN DRIVING IN HEAVY RAIN.
DO NOT DRIVE THROUGH DEEP STANDING WATER.
Filter service - A filter service kit is available from LPE for cleaning and re-oiling the air filter (part number SB-
88-0005). The correct amount of oil for this filter element is 39 grams (1.4 ounces) of oil. Replacement filters are
also available from LPE (filter part number L660070105). How frequently you should clean your filter will depend
on your driving conditions. LPE recommends checking your filter at every oil change or 3,000 miles. If there is a
build up of dirt as thick as the wire mesh, then LPE recommends you clean your filter. As dirt builds up on your
filter, the restriction of the airflow also increases.
Many other items are available from LPE for your Z06 Corvette including low temperature thermostats, cam-
shafts, ported throttle bodies, port matched intake manifolds, intake manifolds, turbocharged engine packages
and much more. Contact LPE, visit our web site, or contact your LPE distributor for information about our other
products.