Lingenfelter L650100206 PP C6 Z06 Corvette Air Intake Instructions v3.02 small - Manual (Page 5)

Page 4 of 8
Reinstall modified radiator shroud. Install two push fasteners,
securing the shroud to the bumper beam.
Install oil cooler, securing it in place with the four bolts previ-
ously removed. Install the two oil lines into the oil cooler ports.
IMPORTANT - oil lines must be pushed in and then pulled back
to verify proper engagement.
From the top side, install the two factory “Christmas tree” fas-
teners holding the radiator shroud to the condenser.
Remove the protective cover from the LPE supplied air filter.
NOTE: Inspect inside of filter for any debris prior to installing in the vehicle. Be very careful during the remain-
der of the installation process to not let any dirt or objects fall
into the filter.
Thoroughly clean edge of airbox with supplied alcohol pad.
Cut supplied foam seal to fit airbox as shown in image. Install
rubber seal to three edges of airbox as shown. Make sure the
foam seal does not interfere with the mounting holes.
Slide airbox and filter assembly in place as shown.
Use four of the supplied push lock plastic rivet fasteners to
secure the airbox flange to the shroud. Pinch pieces together
as tight as possible while securing the fasteners.
From underneath the vehicle, starting with the bottom, center
fastener, install the remaining seven fasteners, pinching pieces
tight together while fastening.
Remove two plastic pins from the top mount radiator shroud
by prying up center nail, then pulling out (as shown in image).
Install the two supplied “Christmas tree” fasteners into same
holes that held the two plastic pins. Install top radiator shroud
ensuring it engages fan shroud in the center as shown. Tuck
water hose back into holders on shroud, secure with four bolts
previously removed.