Lingenfelter EFILive AutoCal Instructions v0.6 - Manual (Page 3)

Page 2.
5. First screen will say “Display DTCs.” This is
used to display diagnostic test codes
6. Use the right down arrow (NEXT) button to
go to the next menu option:
7. Clear DTCs: This is used to clear any stored
diagnostic test codes. Only clear codes after
documenting what the stored codes are.
8. Right arrow (NEXT) again to get to:
9. Select PIDs. Press the middle button (OK) to
choose this function
10. You can now use the up and down arrows to
select what group of variables you want to
data log. The first set of variables is usually
pre-set by LPE to be the group of variables
that you want to data log. In some cases the
AutoCAL units may be programmed with
more than one group of variables in order to
be able to look at different data on the same
or different vehicles.
11. The first set of PIDs on the AutoCAL device
are for the 2008-2012 Suburban and Yukon
XL and are named: E38-T43
12. With this visible on the screen, press OK.
13. Screen will then display “PLEASE WAIT….”