Lingenfelter EFILive AutoCal Instructions v0.6 - Manual (Page 14)

Page 13.
11. When the screen on the AutoCal says
“Ignition Off NOW!”, turn the ignition to the off
position and press OK.
10. After the original calibration is erased from
the ECM, the AutoCal will automatically
begin to flash the new calibration to the
vehicle. When the percentage reaches
100%, the new calibration has been flashed
to the vehicle, which will take roughly 10-
20 seconds to perform just a “Program”
calibration.
9. The AutoCal will now erase the existing
calibration from the ECM, as shown in the
adjacent picture.
8. The AutoCal will now display “Checking” and
a completion percentage. The AutoCal will
reach 100% in a few seconds.