Lingenfelter EFILive AutoCal Instructions v0.6 - Manual (Page 13)

Page
5. Press the down arrow (NEXT) button
until you reach the “PROG” options. The
Lingenfelter AutoCal has enough internal
memory to store up to 5 different calibration
programs which are labeled “Prog 1” through
“Prog 5” on the AutoCal. Press the NEXT
button to scroll through the five different
Program locations. Select the desired
calibration to be uploaded to the vehicle and
press OK.
NOTE: If you are wanting to flash just a new
calibration to the vehicle, you will want to
select one of the “PROG” options. If you are
wanting to flash a new calibration AND and
new vehicle operating system to the vehicle,
you will want to select one of the “FULL”
options.
12.
7. The AutoCal will then prompt you to confirm
that you want to license the ECU to the
AutoCal. Press OK to confirm and the ECU
will be licensed to the AutoCal
License
ECU Now?
Are you
Sure?
6. The first time that you use the AutoCal to
program a controller, the controller must be
given a VIN license. If this is the first time
that you are using the device to program the
controller, you will be prompted to license
the ECU by the message in the adjacent
illustration. Press OK to license the ECU to
the AutoCal.