Imaxrc B606-AC-PRO - Manual (Page 8)

Tips: if the voltage of charging battery is lower than 2.5V, V may can not be perceived, this will cause a danger of
discharge. You can connect a temperature sensor or use the charger current above 1C to avoid it.
There is a 3-pin port on the left side of the unit. It can be used as a temperature sensor port or USB port, if the port is
assigned as a temp.port, you can use an optional temperature probe to contact the surface of battery (see the screen )
and you can set the maximum temperature at which the danger should allow battery to reach during charge, once a
battery reaches this value the process will be terminated to protect the battery. When it is selected as an USB port, you can
connect the charger to your PC with an optional USB cable. This can utilize the optional software that can show you the
charge process at PC. (See the screen )
When NiMH or Nicd battery is on the cyclic process of charge/discharge, it can often become warm. The program insert
a time delay to occur after each charge and discharge process to allow the battery adequate time to cool down before
being subjected to the next process. (See the screen ) the value ranges from 1 to 60 minutes. If you are not sure, you
can set it over 10minutes.
The charger will automatically supply the trickle function to achieve the full charge with out overheating the battery
fast charge has been terminated. You can alter the trickle value when the charger shows you the screen
When you start a charger process, the integral safety timer automatically starts running at the same time. This is
programmed to prevent overcharge the battery. If it proves to be faulty ,or if the temination circuit cannot detect the
battery full. shows you this program can be on or off, and you can set the maximum safety time, the value ranges from
10 to 720min.As the same principle, there is maximum-capacity-limited function. See , the value ranges from 10 to
20000mAh.
At the screen you can set the audible sounds to be on or off by this program.
When you use the car battery to supply power for charger, screen shows you this program monitors the voltage of
input DC battery. If the voltage drops below the value you set the operation forcibly terminated to protect the input attery.
You can adjust the brightness of LCD screen at the charger (see )
Please refer the information below (chart A), and select the correct parameter for each battery, or it will cause a
serious result!
A3
A4
A5
A7
A9
A6
A8
A10
A11
item Li-Po Li-10 Li-Fe NiMH NiCD Pb
Standard voltage
(V/cell)
3.70 3.60 3.30 1.20 1.20 2.00
Max. Charge voltage
cut off level (V/cell)
4.20 4.10 3.60 1.60 1.60 2.45
Allowable fast
current
1 C 1 C 4 C 2 C 2 C 0 .4C
Min. Discharge voltage
cut off level (V/cell)
3.00 3.00 2.00 1.00 0.85 1.75
types
