Imaxrc B606-AC-PRO - Manual (Page 13)

After check all the mode, to start the process press key for more than 2 seconds.
The screen displays the present state of process. To stop It press key;
Description: :the type of battery, :operating mode: CHG=charge
DSC=discharge DCHG>CHG or CHG>DCHG=the cycle mode; :elapsed time,
:charge/discharge current of the battery, :voltage of the battery pack,
:capacity of charge/discharge
Enter
Start
Mode
Esc
Mode
Esc
You can inquire the temperature and V continuaIIy by press Key
1 2
3
4 5
6
Dec./Inc.
This is programmed for charging Pb battery with nominal voltage from 2 to 24v, Pb battery can not be charged rapidly. They
can only deliver relatively lower current compare to their capacity. The optimal charge current will be 1/10 of the capacity.
Please always follow the instruction supplied by the manufacturer of battery.
Pb battery program
charging Pb battery
Enter
Start

As you can see on left, you can set up the charge current on the left. The nominal of the
second line and voltage of the battery on the right of the second line. The charge current
ranges from 0.1-10.0A and the voltage should be matched with the battery being charged.
Start the charge process by pressing key for more than 2 seconds.
The screen displays the state of charging process. To stop charging forcibly, press key
once.
NiMH CHARGE Aut
CUR LINIT 5.0A
NiMH DISCHARGE
1.0A 11.5V NiMH 2.0A 7.42V
CHG 022:45 00890
NiMH CYCLE
DCHG CHG 3
v
Pb CHARGE
4.0A 12.0V(6P)
Pb-6 4.0A 12.59V
CHG 022:43 00682
Mode/Esc
Enter
Start >2S
Enter
Start >2S
1 2 3 4 5 6
Mode
Esc