Initial parameter set up – Imaxrc B606-AC-PRO User Manual
Page 7

Initial parameter set up
Tip: please set up correctly in the “user set” menu before into the job
for the first time you use it.
Press key to the first screen on the left, then press key to
enter the into parameter setting menu.
This charger can accept three types of Lithium batteries: LiPo/Lilo/LiFe;
you have to check the battery carefully and set it up correctly, or it will
cause an explosion! (Please refer the table A)
Normally, 10minutes are enough to perceive it correctly. For the
battery of larger capacity, you may reduce the term or use with the
default value.
Enter
Start
Mode
Esc
You can switch at the same level menu by key.Please refer the
detailed flow chart on the left.
Dec./Inc.
When you are willing to alter the parameter value in the program,
press key to make it blink, then change the value with key.
The value will be stored by press key once.
Enter
Start
Enter
Start
Dec./Inc.
This charge can recognize the cell count of Lithium battery automati-
cally at the beginning of charge or discharge process to avoid from
erroneous setting by user. But deeply discharged battery can be
perceived incorrectly. To prevent the error, you can set the time term
to verify the cell count by the processor. (See the screen )
A0
A0
A2
A3
A4
A5
A7
A9
A6
A8
A10
A11
A1
A2
A1
USER SET
PROGRAM
LiPo/Lilo/LiFe
CHK Time 10 min
NiMH Sensitivity
D.Peak Default
NiCd Sensitivity
D.Peak Default
Waste Time
CHG DCHG 5min
NiMH/NiCd/Pb
TricKle 100mA
Safety Timer
ON 120min
Capacity Cut-off
ON 500mAh
Key Beep ON
Buzzer ON
Input Power Low
Cut-off 10.5V
BacK-light
100%
Lilo
V.TYPE 3.6V
LiFe
V.TYPE 3.3V
USB/Temp Select
Temp Cut-off 80C
USB/Temp Select
USB Enable
LiPo
V.TYPE 3.7V
Mode/Esc
Enter
Dec.
Inc.
Dec.
Dec.
Inc.
Dec.
Inc.
Dec.
Inc.
Dec.
Inc.
Dec.
Inc.
Dec.
Inc.
Dec.
Inc.
Dec.
Inc.
Dec.
Inc.
Dec.
Inc.
v
Inc.
shows the trigger voltage for automatic charge termination of
NiMH and NiCd battery( V), the effective value ranges from 2 to 20mV
per cell. If V is set higher, there is a danger of overcharging the
battery; if it is set lower, there is a possibility of premature of
termination. Please refer technical specification of the battery. (NiCd:
12mV, NiMH: 7mV)