Imaxrc B606-AC-PRO - Manual (Page 14)

discharging Pb battery
Set discharge current on the left and final voltage on the right, the discharge current ranges
from 0.1-5.0A and the voltage should be matched with battery being discharged. Start the
discharge process by pressing key for more than 2 seconds. Enter
Start
The screen displays the current state of discharge.
save data and load data program
This charger can store /load up to 5 data of batteries, you can out the data for the process without setting up the
program again.
save data
Press key to the screen on the left, then press key to enter into the submenu.
The blinking (01) shows you the data No, you can press key to change it. Press
key can select the type of battery, voltage, capacity, and you can set them by pressing
key, then press key for more than 2 seconds to select the charge mode.
Mode
Esc
Mode
Esc
Enter
Start
Enter
Start
Enter
Start
Dec./Inc.
Dec./Inc.
Dec./Inc.
Setting up charge/discharge current and final voltage.
To save the data, press key for more than 2 seconds. Enter
Start
Enter
Start
Enter
Start
load data
Press key to the screen on the
left, and then press key to enter
the submenu.
You can press key to
select the data number when
the (01) field is blinking.
Press key for more than 2
seconds, it will show you the left
screen, loading the data.

PROGRAM SELECT
LOAD DATA LOAD (01) NiMH
14.4V 3000mAh LOAD
Pb DISCHARGE
4.0A 12.0V(6P)
Pb-6 0.4A 12.59V
DSC 022:43 00682
Enter
Start >2S
Enter
Start >2S
Enter
Start >2S
Enter
Start >2S
Mode
Esc
Mode
Esc
PROGRAM SELECT
SAVE DATA
SAVE (01) NiMH
14.4V 3000mAh
NiMH CHARGE AT*
CUR LIMIT 5.0A
SAVE
Enter
Start
Enter
Start