beautypg.com

Maintenance, 19 replacement of parts – Glow-worm Ultracom2 cxi User Manual

Page 48

background image

0020112601_02 - 10/12 - Glow-worm

- 46 -

MAINTENANCE

19 Replacement of Parts

• Do not use reconditioned or copy parts, only use original

parts supplied by Glow-worm.

• If a part is required, contact the Glow-worm service

organisation.

• Please quote the name of the appliance, this information will

be on the name badge on the front of the appliance.

• If in doubt seek advice from the local gas company or Glow-

worm’s own service organisation.

a

Replacement of parts must be carried out by a

competent person approved at the time by the

Health and Safety Executive.

PLEASE NOTE: During change of part of the combustion

circuit, we recommend that the following is the following must

be checked:

- The integrity of the flue system and the flue seals,

- The integrity of the boiler combustion circuit and the relevant

seals,

- The operational (working) gas inlet pressure at maximum

rate,

- The gas rate,

- The combustion performance.

19.1 General

b

The replacement of parts described in sections

"Combustion block" will require the removal

of the burner module assembly and the

replacement of seal and self locking nuts.

Replacement parts that have associated components that need

replacing on removal, i.e. ‘O’ ring, seals, gasket, etc., will need

to be supplied and should be fitted.

• Before replacing any parts of the boiler, isolate from the

mains electric supply and turn off the gas at the gas service

isolation valve on the boiler.

Unless stated otherwise parts are replaced in the reverse order

to removal.

• After replacing any parts, always test for gas soundness and

if necessary carry out functional test of the controls.

19.2 boiler Access

For replacement of parts, the front casing panel of the boiler will

need to be removed.

• To remove undo the two screws on the underside of the front

casing and lift off.

19.3 Viewing window

24

V

230

V

1

1

2

3

4

5

Key

1 fibre washer

2 Steel washer

3 Glass

4 Steel washer

5 Circlip

• Remove the circlip (5).

• Remove the steel washer (4).

• Remove fibre washer (1).

• Remove the glass (3).