beautypg.com

Installation – Glow-worm Ultracom2 cxi User Manual

Page 28

background image

0020112601_02 - 10/12 - Glow-worm

- 26 -

INSTALLATION

12.3 filling DHW Circuit

• Open the various hot water taps to fill the DHW circuit.

12.4 filling the Condensate Trap

A

B

C

1

1

2

Key

1 filling trap

2 Condensate trap

• Fill the trap 3/4 full with water (1).

• Activate the Heating and Domestic Hot Water functions.

• Run the appliance for at least 15 minutes, with a heating

temperature set to greater than or equal to 50°C (not

applicable for an installation with underfloor heating).

• Vent air from each radiator again until the water flows

normally, then close the vents.

• If you have difficulties in removing the air, launch the air-

removal programs in the heating circuit (see the chapter

("Technical settings for the appliance and list of parameters").

• Make sure that the pressure indicator shows a value of 0.8

bars; otherwise, fill the appliance again.

12.5 Initial lighting

12.5.1

Control

i

The combustion for this appliance has been

checked, adjusted and preset at the factory for

operation on natural gas (G20) as defined on the

appliance data label.

No measurement of the combustion is necessary.

Should the appliance require to be converted to LPG

gas ensure you follow the gas conversion section

before lighting the boiler.

• Check that the appliance has been installed in accordance

with the instructions.

• Check the integrity of the flue system and flue seals.

• Check the integrity of the appliance combustion circuit and

relevant seals.

• Check that all internal/external controls are calling for heat.

• Check that the gas service isolation is open.

• To adapt the appliance to another type of gas, see chapter

"LPG conversion".

12.5.2

Adjusting the temperature

3

2

1

6

5

4

Key

1 Domestic hot water temperature control buttons

2 Display

3 Reset button

4 On/Off button

5 Central heating temperature control button

6 Mode selection button

• Light the appliance by following the procedure below.

• Select the "Heating + domestic hot water" function by

pressing the “Mode” button repeatedly to scroll through your

options until are shown.

The appliance will enter a self checking routine, then the fan

will start and the ignition sequence commence. The boiler, if

necessary, will automatically repeat the ignition sequence a

further 4 times.

If the burner fails to ignite “F28” will be displayed, initially, this

may be due to air in the gas supply line. Press the reset button.

Do not use the reset button to purge the installation - never

press reset more than 3 times.

• Press the central heating water temperature button and

the factory setting temperature will be displayed.

• Press or buttons to adjust.

• Press the hot water temperature button and the factory

setting temperature will be displayed.

• Press or buttons to adjust.

• Open a hot water tap, the display will indicate the domestic

hot water temperature.

• Check that hot water is available at all taps, then close.