FeiYu Tech Panda Autopilot - Manual (Page 16)

Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [email protected]
Page 15
a) Your RC Receiver is installed at your ground station. The Receiver servo signal output is
fed into the Remote Adapter.
b) The signals received by the Remote Adapter will be converted to digital signals. The Data
Radio system then up-loads these digital commands to your aircraft.
c) The uploading of data to the aircraft does not involve the GCS. The GCS is only used to
monitor telemetry and flight status of the aircraft. GCS involvement in
fight control is minimal.
d) Warning: In Option 1, the Data Radio range will dictate your flight range. Additionally,
due to the digital signal conversion and processing, some delay in manual control
transmission will occur. Refer page 7 on notes on data transfer frequency (Hz).
Figure 1: On the aircraft, the radio
modem controls all flight parameters.
No RC receiver is installed in your
aircraft.
Figure 2: At your ground Station, the
signals from your RC Transmitter is
sent to the RC Receiver which is
connected to your computer via the
Remote Adapter.