Austin Hughes IPM-02 - Manual (Page 39)

www.austin-hughes.com UM-IPM-02-Q414V3 P.34
Step 5
. Select the SNMP from the left navigation
Step 6 . The SNMP Settings window appears as below:
Step 7
. Click “ Enable “ in “ SNMP Agent “ to start the SNMP agent service
Step 8
. Input “ Read Community “. Default is “ public ”
Step 9
. Input “ Write Community “. Default is “ private ”
Step 10
. Select “ disabled “ or “ V2Trap “ in “ SNMP Traps “
If select “ V2Trap “ , please input IP address of the SNMP management station in “ Station IP: “
Step 11 . Click “ Apply “ to fi nish the SNMP settings
Part VI. SNMP Setup / Firmware Upgrade