Aiwa CX NMA545 - Manual (Page 24)

CLOCK AND TIMER
¡LiaS
SETTING THE SLEEP TIMER
The clock is displayed. (The between the hours and minutes
flashes.) When the power cord is plugged into an AC outiet
for the first time after purchase or when the ciock setting is
canceied due to a power failure, the entire clock display
flashes.
1 Press CLOCK.
=■■== .i.
2 Within 4 seconds, turn MULTi JOG to designate
the hour and the minute.
Turning MULTI JOG changes both the hour and the minute.
◄◄ or ►► is aiso available instead of MULTI JOG. Holding
these buttons down will vary the time rapidly.
3 Press ENTER or II.
The clock starts from 00 seconds.
To restore an original clock setting
Press CLOCK before completing step 3 to restore the previous
time setting. This cancels any new setting.
To view the clock when another display is in the display
Press CLOCK. The time is displayed for 4 seconds and then the
original display reappears. However, the clock cannot be
displayed during recording.
To switch to the 24-hour standard
Press the CLOCK and then press ■ within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
If the display flashes when the clock is displayed, it indicates
that the clock has stopped due to a power failure or the removal
of the power cord. The current time needs to be reset.
The unit can be turned off automatically at a specified time.
Use the remote control.
1 Press SLEEP.
■^SLEEP EE
2 Within 4 seconds, turn MULTI JOG to specify the
time until the power is turned off.
The time changes between 5 and 240 minutes in 5-minute
steps.
and ►>- are also available instead of MULTI JOG.
Specified time
“'•"Esic
EL.EEP
While the timer is in operation, the display indication is dimmer
than usual.
To check the time remaining until the power is turned off
Press SLEEP once. The remaining time is displayed for 4
seconds.
To cancel the sleep timer
Press SLEEP twice so that “SLEEP oFF” appears on the display.
If the power-economizing mode (page 9) is on, all the display
lights turn off when the power is turned off. To view the clock,
press
CLOCK so that the time is displayed for 4 seconds.
24
ENGLISH