Aiwa CX NMA545 - Manual (Page 10)

SOUND
GRAPHIC EQUALIZER
-GEQ
VOLUME
Turn VOLUME on the main unit, or press VOL on the
remote control.
The volume level is displayed as a number from 0 to MAX (50).
The volume level is automatically set to 20 when the power is
turned off with the volume level set to 21 or more.
To change the left/right balance
Press MANUAL SELECT on the remote control. L/R is displayed
for 2 seconds. Press ◄◄ DOWN or ►► UP on the remote control
within these 2 seconds.
• The DOLBY PRO LOGIC front speakers level is also changed.
(See page 20)
SUPER T-BASS SYSTEM
The T-BASS system enhances the realism of low-frequency
sound.
Press T-BASS.
Each time it is pressed, the level changes. Select one of the
three levels, or the off position to suit your preference.
S ".;!= == 00
Low frequency sound may be distorted when the T-BASS system
is used for a disc or tape in which low frequency sound is originally
emphasized. In this case, cancel the T-BASS system.
This unit provides the following three different equalization curves.
ROCK: Powerful sound emphasizing treble and bass
POP: More presence in the vocals and midrange
CLASSIC: Enriched sound with heavy bass and fine treble.
Press one of ROCK, POP or CLASSIC.
The selected equalization mode is displayed.
W-.
R O C K
To cancel the selected mode
Press the selected button again. “GEQ OFF” is displayed.
To select with the remote control
Press GEQ repeatedly. The GEQ mode is displayed cyclically
as follows.
C
ROCK- POP - CLASSIC- GEQ OFF tu un--------- 1
(cancel) I
Using the headphones
Connect headphones to the PHONES jack with a standard stereo
plug ( 06.3 mm, 'U inch).
No sound is output from the speakers while the headphones are
plugged in.
• When the headphones are plugged in, the DOLBY PROLOGIC
is canceled.
Sound adjustment during recording
The output volume and tone of the speakers or headphones are
freely varied without affecting the recording.
1 0
ENGLISH