Aiwa CX NMA545 - Manual (Page 16)

RECORDIN<
BASIC RECORDIN
Sound adjustment during recording
The output volume and tone of the speakers or headphones are
freely varied without affecting of the recording.
This section explains how to record from the tuner, CD player, or
external equipment.
'•/OREC/
REC MUTE
Preparation
• Use Type I (normal) tapes only.
• Set the tape to the point where recording will start.
• Note that recording is done on only one side of the tape.
1 Insert the tape to be recorded on into deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
•±PUSH EJECT
2 Press function (CD, TUNER or VIDEO/AUX) and
prepare the source to be recorded.
To record from a CD. press CD and load the disc(s).
To record from a radio broadcast, press TUNER and tune
in to a station.
To record from a connected source, press ViDEO/AUX.
3 Press • REC/REC MUTE to start recording.
When recording from a connected source, start playback of
the source.
^ ^_^ j_^
r i s 3 ==
INSERTING BLANK SPACES
Insertion of 4-second blank spaces enables you to activate the
Music Sensor function. (Applicable when the source is TUNER
or VIDEO/AUX.)
1 Press # REC/REC MUTE during recording or while in
recording pause mode.
on the display flashes for 4 seconds and 4-second blank
space is made. Then, the deck enters the recording pause
mode.
2 Press II to resume recording.
To insert a blank space of less than 4 seconds, press •
REC/REC MUTE again while is flashing.
To insert blank spaces of more than 4 seconds, after the deck
enters recording pause mode, press • REC/REC MUTE again.
Each time the button is pressed, a 4-second blank space is
added.
About cassette tapes
• To prevent accidental erasure,
break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
To record on the tape again, cover the tab openings with
adhesive tape, etc.
• 120-minute or longer tapes are extremely thin and easily
deformed or damaged. They are not recommended.
> Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may breaker jam in the mechanism.
When the selected function is CD, playback and recording
start simultaneously.
To stop recording, press ■.
To pause recording, press II. (Applicable when the source is
TUNER or VIDEO/AUX) To resume recording, press it again.
To start recording with the remote control
First press #/0 REC/REC MUTE, and then press ►/◄► within
2 seconds.
1 6
ENGLISH
“CANT REC” is displayed if you attempt to record on a tape with
the plastic tabs broken off.
To erase a recording
Make sure the microphone is not connected to this unit.
Turn MIC MIXING control to MIN (See page 22).
1 Insert the tape to be erased into deck 2 and press TAPE DECK
1/2 to display “TP 2”.
2 Set the tape to the point where the erasure is to be started.
3 Press • REC/REC MUTE to start the erasure.