IC Realtime 2Mp 30x Optical Zoom Full HD Network PTZ Dome Camera with 300ft IR (ICIP3001HDIR) - Manual (Page 16)

10
ADDR ：001-H
BAUD RATE ：9600
PARITY ：NONE
SOFTWARE ：V1.02.0.RHNDDC BACK
EXIT
SYSTEM INFORMATION
DISPLAY SETTING
CAMERA SETTING
FUNCTION SETTING
IR LIGHT SETTING
EXIT
Note:
z
ERR means current setup is invalid.
z Please make sure all the cable connections are right.
4.2 Self-diagnosis System Information
After installation, please connect speed dome to power. The system goes on a self-diagnosis, and then it
pops up the above interface to show the system information.
If there is anything wrong during the self-diagnosis, system pops up error code.
The above interface disappears after speed dome received the first command (or the display time lasts for
20 seconds.)
z
ADDR: Here you can view dome address information. For example, 001-H, 1 is the address number, -H
is hard address mode. –S is software address mode.
z Baud rate: Dome communication baud rate.
z Parity: Communication parity bit format.
z Software: Dome PTZ software version.
When you are using the control keyboard or the matrix host to control the device, please make sure
the control parameter of the keyboard or the matrix host is the same with the speed dome OSD
(including address, baud rate, parity). Please make sure the cable connection is OK.
4.3 Main Menu
You can open the IP dome menu via control keyboard, matrix, or speed dome control terminal.
z SYSTEM INFORMATION：Dome self-diagnosis information, address information, system time setup,
set north direction, language, factory default setup, reboot and so on.
z DISPLAY INFORMATION: Display dome preset title, azimuth display, time, direction, dome internal
temperature and etc information.
z CAMERA PARAMETERS ：Display dome white balance setup, camera function setup, day/night setup,
shutter setup and etc.
z FUNCTION SETTING: Set preset, pan, scan, auto cruise, pattern, idle function, time task and privacy
mask function.
z IR LIGHT SETTING: Set dome IR sensitivity, IR control principle, medium and far light bright, far light
bright, IR light compensation and etc.
z EXIT: Log out the system menu.