Setting the distinctive ringing function -16 – Brother 875 MC User Manual
Page 84
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
3. Press
6
.
4.
Press
(left
arrow)
or
(right
arrow) to find the SET mode.
5. Press
SET.
6
. Press
STOP.
NOTE:
The
display
should
say
D/R
SET
MODE.
Also,
the
answer
mode
lights
will
flash.
You
must
now
wait
for
someone
to
call
the
distinctive ringing fax number.
7.
When the phone rings, listen care
fully to check that the ringing pat
tern is the one you want to register.
If it is, wait (at least two ring cy
cles) until the display says
PICK
UP TO SET.
Then pick up the fax
handset.
8
. Press
START
to set.
Check that the display says
REGISTERED.
(If the other number was called, press
STOP
to cancel.)
9. Hang up the handset.
^ iiiiiciigiiiMiiiiiPM
iiiaiMMiBiiiiiMiiti
liiBiiiigMifiiiiaiM
iiiiiiiiiiiiiiiiia'iifi
After you complete this one-time setup:
1.
The
Distinctive
Ringing
function
automatical^^
will
be
changed
from
SET
to
ON,
Set
the
answer mode based upon your needs (see page 7-15).
2. Be sure to have your friend call you on both numbers to test that everything is set up correctly.
3.
If you do not complete this function by pressing START to register a number, your machine will
stay in MANUAL mode, So, if you decide not to register a number, you must repeat Steps 1-
6 and in Step 4 change the mode to OFF.
How to Turn the Distinctive Ringing Function ON or OFF
The
distinctive
ringing
function
is
designed
to
accommodate
the
distinctive
ringing
service
(a
telephone
service that provides you
with a multiple numbers, each with a distinctive ring pattern,
on one line). You can change the distinctive ringing function setting to ON or OFF as needed after
you
have
registered
the
distinctive
ringing
number
in
the
function
called
Setting
the
Distinctive
Ringing Function. To change the setting, repeat Steps 1-6 above; Step 4 is where you can select
either ON or OFF,
7-17