Brother 875 MC - Manual (Page 117)

KEYS TO PRESS THE DISPLAY WILL SHOW:
1. Press FUNCTION.
2 . Press 8 .
3. Press 4.
4. Enter a three digit number 000 to
999. The last digit, an asterisk, can
not be changed.
Example: 160*.
5. Wait for two seconds.
6 . Press STOP to exit.
ижшшмвияндюи
йдшй1жамш11шя
ЮДЯЮ1ЯШШ1Ш11
Using the Remote Access Code
1 . Pick up the handset of a remote touch tone phone or fax machine.
2. Dial your fax machine’s number.
3. When your fax machine answers with a beep, immediately press your Remote
Access Code 159* (factory setting).
If your fax machine is in MANUAL mode, you can access the Message Center by waiting for
20 rings and then pressing the code within 30 seconds.
4. The fax machine will tell you the kind of message(s) it has received;
One long beep: Received FAX inessage(s).
Two long beeps; Received TAD message(s).
Three long beeps: Received both FAX and TAD messages.
(No long beeps: No message(s) have been received.)
5. As soon as you hear two (2) short beeps, press a Control Command.
Each time your fax machine completes an instruction, it gives two (2) short beeps telling you
to enter the next command; if you wait longer than 30 seconds to enter the command, your
machine will disconnect the line. If you perform a wrong operation, you will hear' three (3) short
beeps.
6 . When you are ready to exit remote control mode, press 90 to reset your machine.
10-21