Brother Fax-615 - Manual (Page 31)

KSWplii,
4. TELEPHONE FUNCTION SETTINGS
There are some settings, such as the date and time, you should make to your fax machine before
you begin usingit. Once entered, these settings will remain in the machine until you change them.
You can begin customizing the settings by pressing
FUNCTION on the control panel. This
activates the function mode and On - Screen Programming prompts. You can complete a variety
of settings in this mode.
Setting the Dialing Mode (TonefPulse)
Your fax machine supports both tone (or multi-frequency) and pulse (or rotary) dialing. It is
initially set to TONE, so you do not need to change the setting if you use that kind of line. If you
are using a pulse dial line, you can change the setting to PULSE by following the steps below;
THE DISPLAY WILL SHOW:
iliiiiiliiiliiiiii
1. Press FUNCTION.
You will see scrolling options on the dis­
play. You can choose one.
liliiliiliiillliiBiiii
2. Press 6.
3. Press 1.
After two seconds you will be automati­
cally prompted to select pulse or tone.
iilllillillililliiii
iiiiiiiiiilililllilill
4. Press (left arrow) or (right
arrow) to find the dialing mode
that matches your telephone line.
Example: PULSE.
iiiiiliiiiliiliBliiiii
5. Press SET. iiiiiiliiiililiisiillill)
6. Press STOP to return to the date
and time.
Setting the Beeper Sound Level
If the beeper setting is LOW or HIGH, it will “beep”
or at the end of sending or receiving a fax.
every time you press a key, make an error.
The initial setting on your fax machine for the beeper is LOW. If you do not want the beeper on,
select OFF, and if you want it loud, select HIGH.
4~1