AltiGen IP 705 - Manual (Page 30)

22 IP 705 Manual
—LOADING FW...
—LOADING NOW.
—Boot Done
—INITIALIZING
—Version xxxx.xxxx.xxxx
10. You may display the version of firmware at any time: Press the Menu
button, scroll to SYSTEM and press Enter, scroll to Version Info
and press Enter.
Configuring NAT
Note: This section is only for an IP 705 phone that is using an H.323
version of AltiGen phone firmware.
NAT (Network Address Translation) is the translation of an IP address
used within one network to a different IP address known within another
network. One network is designated as the inside network, the other is the
outside. The IP 705 can be enabled to support H.323 behind NAT. The IP
705 will be able to work behind a regular NAT router without any special
implementation for H.323.
Note: If more than one IP 705 phone sits behind NAT, a VPN tunnel is
required to connect between the NAT router and the corporate
router.
Setting Ring Tones
To set the ring tone:
1. Press the Menu button.
2. Select PHONE SETTING, then press the Enter button.
3. Scroll to RING TONES and press Enter.
4. Scroll to the desired ring tone and press Enter.
When new ring tones are added to the server, they can be downloaded from
the phone. To download ring tones:
1. Select PHONE SETTING and press Enter.
2. Select RING DOWNLOAD and press Enter.
3. Select YES and press Enter.