Adaptive Technologies UB-3RDX-60 User Manual

Page 2



2013 Adaptive Technologies Group, Inc. www.adapttechgroup.com

REV00-1213

Figure 2

Step 1: Install Pipe Extension
Anchor the selected pipe extension in the vertical orientation. Be sure that it is fully secured and cannot un-
thread itself over time. Use a schedule-40 ½” NPT or BSPT pipe and run the signal wire through with plenty of
extra wire to reach the speaker’s terminal block before attaching the UB-3RDX-60. (Figure 1)

Step 2: Attach UB-3RDX-60 to the Pipe Extension
Pull the extra length of signal wire through the top of the Mount’s pipe fitting then fully thread the mount onto
the pipe until tight (figure 2).

Step 3: Attach U-Bracket and Speaker to the UB-3RDX-60
Secure the U-Bracket to the loudspeaker then match up the holes of the U-Bracket with the UB-3RDX-60 and
bolt the two assemblies together permanently using the supplied bolts, washers and nuts (figure 2).

Step 4: Aim and Wire Speaker

(a) Rotate the speaker horizontally into the desired direction. Permanently tighten the side set screw of the

UB-3RDX-60 into the pipe to prevent the mount from un-threading itself.

(b) Rotate the speaker and U-Bracket relative to the vertical pipe to get the desired lateral tilt angle.

Tighten the bolts of the UB-3RDX-60 permanently.

(Figure 2)

If any of these angles require further adjustment, loosen the bolts first then rotate the speaker to the new
angle. When satisfied with the aiming of the speaker, permanently tighten all bolts and hardware.

Step 5:
Connect signal wire to the
speaker terminals and secure
a safety cable to the
speaker and the upper
structure.