Adaptive Technologies SAS-100-CM User Manual

Installation instructions

Figure 2

SAS-100-CM Ceiling Mount

Adjustable Tilt Cable Application

Installation Instructions

Thank you for selecting the SAS-100-CM

Steerable Speaker Ceiling Mount. This

universal ceiling speaker mount provides a 360° pan angle adjustment. It suspends

and precisely aims speakers equipped with rigging points from ceilings and other

structural overhead surfaces.

Important:

Mounting and rigging video equipment requires experienced professionals.

Improperly installed video equipment can result in property damage,

personal injury, death and/or liability to the installing contractor.

Do not

install if in doubt about the integrity of the mounting structure.

Caution:

Due to the wide variety of building structures, materials and mounting methods, these

instructions assume that the installing the contractor/installer will exercise good

judgment in selecting proper mounting area and hardware.

As a guide, the installation, when completed should be capable of supporting at least 5

times the actual applied load.

Follow these instructions for the most efficient and safest mounting results.

Step 1. Install Ceiling Plate:

Secure the ceiling plate above a structurally sound horizontal grid. Be sure the ceiling plate

center is level and directly above your desired suspension point (Figure 1).

If you have

doubts about the integrity of the structure you are mounting to, or you are not sure about

the proper hardware to use, consult your local hardware specialist.

Step 2. Install Extension Coupler:

Thread the extension coupling into the threaded hub of the ceiling plate, then place the

wire mesh cover around it(Figure 1).

Step 3. Assemble the Cross Arm:

Permanently attach the eyebolts to the cross bar with flat washers and Nylock nuts then the end

caps (Figure 2).

Step 4. Assemble the Center

Hub:

Assemble the hub to the cross arm

using the hex bolt, washers, Teflon

washer and Nylock nut. Insert the

cotter pin into the hole of the 1/2”

bolt then fold the end to secure

(Figure 3).

Step 5. Install Cross Arm to

Ceiling Plate:

Align and hand thread the hubcap

of the cross arm assembly over the

extension coupling inside the ceiling plate. Use a pipe wrench to tighten connection permanently (Figure 4). Slip mesh

evenly over both hubs.

Figure 1

Figure 3