Adaptive Technologies MM-010-BT User Manual

Page 2

07/02/04

Step 2: Attach Mount to Speaker

Attach the speaker mount to the appropriate mounting holes of the

speaker. Use the radius slot if necessary to allow for a clockwise rotation

(Figure 2). If threaded inserts are not provided, consult the speaker

manufacturer for the recommended mounting procedure.

Step 3:

Lift the assembled speaker and mount and insert the support arm into

the top of the wall mounting plate. Line up the threaded hole of the

support arm with the open slot for pan angle installation (Figure 1A) or to the

second barrel hole for no pan angle installation (Figure 1B). Install the included

socket screw and flat washer until snug. Be sure the flat washer seats outside the

slot.

Step 4: Pan Angle Adjustment:

Loosen socket screw on the wall mounting plate (do not remove). Pivot the speaker

horizontally until the speaker is aimed into the desired direction then tighten the

socket screw at the mounting plate permanently

(Figure 4).

Step 5: Tilt Angle Adjustment:

While supporting the speaker’s weight, loosen the socket screw on the side of the

speaker adapter plate (do not remove). Tilt the speaker to the desired tilt angle the

retighten the side socket screw of the speaker adapter plate. Be sure that the

screws have been tightened permanently before releasing the weight of the

speaker (Figure 3).

If the tilt angle needs to be adjusted,

do not pull on the speaker

, rather repeat step 5.

Step 6. Recommendation: Install Safety Cable

Attach a safety cable (sold separately) to the mounting surface

(Must be able to support at least five times the

weight of the speaker), then attach the other end of the safety cable to the speaker. If no attachment is provided on

speaker, consult speaker manufacturer for advice on best attachment point and method.

Figure 3

Figure 4