Panasonic NV-F65EA - Manual (Page 12)

EèLÒC PRESE
I
□ III)
III m 3 III m III
DMD III *>□ III m III
III III m in
«□ III m n 111 m III
m a III »□ III W III
»□ in >□ IW m III
III m n III m ail
• a III III m 1»
MD III MD III 31 III
Wl m a III H 111
wC III »□ III H III
m n III a III
Preparation
•Slide down the Mode Selector Cover on the Remote
Controller so that the Bar Code Reader Display can be
seen.
•Press the Digital Scanner On/Off Button to turn it “ON”.
Q Trace the bar code “SETTING OF THE CLOCK”.
SETTING OF THE CLOCK
e Trace the bar code for the year (YEAR).
SS
YEAR
1999 B-
@ Trace the bar code for the month (MONTH).
MONTH
m-mt-
Q Trace the bar code for the day of the month (DATE).
/
5
,
®DATE
rT7i mil I nil ^
@ Trace the bar code for the hour (START TIME).
gnn
©START TIME
9 □-
uu
^ Trace the bar code for the minute (MIN).
MIN
to,
m
•u
Press the Transmit Button (Remote Controlier) and
then confirm that the time is dispiayed in the
Multi-Function Display of the VTR.
crt o
0
c
0
o
P
“Beep-beep-beep-beep-
beep...” sound indicates that
the time setting is completed. |a ^
-Transmit
Button
“Beep”
Sound
@ Press the Digital Scanner On/Off Button to turn it
“OFF”.
• If the transmission was not received correctly, the
“Beep-Beep, Beep-Beep” sound from the VTR will warn
you. In this case, perform transmission again.
• If the Remote Controller is left with no operation per­
formed for more than 4 minutes, it will automatically switch
over to the power-saving standby condition and the lamp
in the reading tip goes out. (In this case, bar codes that
have already been read (but not yet transmitted to the
VTR) will be cancelled.
•The bar codes “SETTING OF THE CLOCK”, “YEAR” and
“MONTH” are located on page 3 of the Programming
Sheet.
( 12 )