Panasonic OMNIVISION PV-8660 - Manual (Page 18)

Timer Recording
‘Important: If the remote control POWER, ACTION, PROG, CHA/V, INDEX or ADD/DLT button does
not work when pressed, press the VCR button on the remote and try the button again.
You can set up the VCR to record a one
time, daily, or weekly program while you are
away or otherwise occupied. Up to 8
programs can be stored in memory.
[^C Check list before you begin.
Q All connections are made.
(See pages 6-9.)
□ TV and VCR are plugged in and turned on,
D VCR/TV selector is set to “VCR."
□ Clock is set to correct time.
□ Record tab in place. (See page 5.)
1
5
é
1
Press PROG* to display the
“SET PROGRAM” screen.
2
Press AT to select “TIMER
PROGRAM,” and then press ►
to display the program screen.
• If a program is already in memory, press AT
and ► to select an unused program number.
............ SET PROGRAM ................
VCR P)us+ PROGRAM
SELECT; A T KEY
SET :► KEY
END : PROG KEY
START STOP CH
CATEGORY:N/A
SELECTrA ▼ KEY
SET ;► KEY
END :PROG KEY
3
Press
AT
and
►
to select and
set one of the following:
• 1-31 =One time recording
• DAILY =Same time MON-FR!
• WEEKLY (SUN-SAT) =Same time once a week
Example ........31 1 2'...... 6-
Today’s Date____7
SELECTA /T
Selection Order DAILY
(^WEEKLY.............WEEKLY___ WEEKLY _J
(SAT) (MON) (SUN)
Press
AT
and
to select and set each
of the remaining
items at right.
4 Prp«i«i A W pnH ^ ^ Remaining Items to be set:
-T rress A T ana ^ w' , start time - STOP time
• CH(annel) number, or LINE
for outside source recording
• Category (N/A [not applicable],
SPORTS, MOVIE, COMEDY,
MUSIC, DRAMA)
• Speed (SP, LP, SLP)
To Make Corrections
Repeatedly press ► to move the cursor to the right, or A to
move to the left to the incorrect entry and make the correction.
5
Press PROG to end the program.
• This screen appears for confirmation.
To Enter More Programs __
Press AT and ► to select and set a blank
program number, and then repeat steps 3 and 4.
6
Press PROG to exit this mode.
7
Press POWER off to set the timer.
• When recording programs via a cable
box, make sure the cable box is left
ON and tuned to the desired channel.
P DT START STOP CH SPD
tWA«fcwti»M^.nrJiRlh33
2 — — ; — — : — — —
3 ----------;----------- -- —
4 ----------;----------- __
CANCEL:ADD/OLT KEY
SELECT 1-8:A ▼ KEY
ENTER :► KEY
END :PROG KEY
tilfildil-
Multi Function Display
Important notes when using a DSS receiver
• When recording programs via a DSS receiver, the DSS receiver must be left on.
• When recording programs via an antenna or cable, the DSS receiver must be turned off.
18
A cassette with no record tab is ejected and “TIMER" flashes when the power is turned off to set the timer.
If the start times of two programs overlap, the tower numbered program will have priority.
If the start time for a timer recording comes up during a normal recording or One Touch Recording (page 16),
the timer recording will not be performed.
If there is a power interruption of more than one minute, the recording will not be performed or continue.