Yamaha RX-V663 - Manual (Page 94)

Customizing this unit (MANUAL SETUP)
3 SOUND MENU
Use this feature to adjust the audio parameters.
3 SOUND MENU
fl)EQUflLIZER
B^LFE LEUEL
ODVNfiMIC RRNGE
D>LIPSVNC
E)EXTD SUR.
[ A ] / [ T ] : IJp/Down
CENTER]: Enter
■ Equalizer H>EQUnLIZER
Use this feature to select the parametric equalizer or the
graphic equalizer.
Equalizer type select EQ TVPE SELECT
Use this feature to select the type of equalizer.
n::'EQUfiLIZER
EQ TVPE SELECT
fiUTO PEQ >GEQ OFF
[NflTURfiL]
C-N]/[^]: Select
CENTER]: Enter
0»>ie«
AUTO PEQ Uses the parametric equalizer adjusted in
“AUTO SETUP” (see page 33).
GEQ Adjusts the built-in 7-frequency band graphic
equalizer so that the tonal quality of the speakers
matches. Press (D ENTER to display the graphic
equalizer screen.
OFF Deactivates the equalizing feature.
Graphic equaiizer GEQ
Use this feature to match the tonal quality of the center,
surround L/R and surround back L/R, and surround back
speakers with that of the front L/R speakers. You can
adjust 7 frequency bands (63 Hz, 160 Hz, 400 Hz, 1 kHz,
2.5 kHz, 6.3 kHz, 16 kHz).
Control range: -6.0 dB to +6.0 dB
Control step: 0.5 dB
fl)EQUfiLIZER 1/2
TEST >0FF ON
CHANNEL--- FRONT L
63Hz —II.. 0dB
160Hz .. II— 0dB
400Hz .. II— 0dB
Ik Hz --ll. 0dB
[ A ] / [ T ] ; IJp/Down
C-Nl/CN-]: belect
i .
A)EQUflLIZER 2/2
TEST >0FF ON
CHANNEL--- FRONT L
- +
^ 2.5kHz »»41-» 0dB
6.3kHz .. II»». 0dB
16kHz .. II. 0dB
[ A ] / [ T ] : IJp/Down
C^]/[^]: Adjust
Press
(DA
/
V
to select a frequency band and
(D<1
/1> to adjust
the selected frequency band.
Note
The “GEQ” parameter can be adjusted only when “GEQ” is
selected in “EQ TYPE SELECT”.
Test tone TEST
Use this feature to make adjustments of “GEQ” while
listening to a test tone. To select “TEST”, press (DA
!
V
repeatedly in the graphic equalizer screen.
fl>EQIJftLIZER
1/2
TEST >0FF
CHfiNNEL-•■•
ON
FRONT
+
63Hz - 0dB
160Hz ..„II— 0dB
400Hz 0dB
IkHz - 0dB
CA]/CT]: Llp/Down
C^]/C^]: Select
Currently applied parametric equalizer type (see page 33) appears
under “AUTO PEQ”.
klilfc
You can select “AUTO PEQ” only when you carry out “AUTO
SETUP” in advance (see page 32). In this case, “AUTO PEQ” is
automatically selected as the default setting.
OFF Does not output test tones and output the
currently selected source component.
ON Outputs test tones from the selected speakers.
90
En