Yamaha RX-V663 - Manual (Page 111)

Advanced setup
See page 106 for the operation of the advanced setup.
■ Remote control AMP ID REMOTE h MP
Use this feature to set the AMP ID of this unit for remote
control recognition. This feature is useful when you
operate this unit and the other Yamaha receivers/
amplifiers in the same room separately.
Choices: ID1, ID2
• Select “IDl” when the remote control AMP ID code is
set to “5019”.
• Select “ID2” when the remote control AMP ID code is
set to “5020”.
Setting remote control AMP ID codes
You need to set the remote control AMP ID code for the
remote control.
1 While pressing and holding (DAMP on the
remote control, press (D AV POWER for
more than 3 seconds.
(DAMP flashes twice.
1 AMP 1 POWER
While holding
Press for 3
down
♦
C a SF]
seconds
:o;
flashes
Press the numeric buttons (®) to enter the
code number “5019” or “5020”.
When the setting succeeds, ® AMP flashes twice;
however, when it does not, (DAMP flashes
repeatedly.
AM»ID
, RttmitE T
. ooiMMAMPl
«•2 '1
5019 To operate this unit using IDl
(initial setting) the default code. (initial setting)
5020
To operate this unit using
an alternative code.
ID2
The remote control setting
*2 The setting of this unit
■ Remote control TUNER ID REMOTE TU
Use this feature to set the TUNER ID of this unit for
remote control recognition.
Choices: ID1, ID2
• Select “ID 1 ” when the remote control TUNER ID code
is set to “5007”.
• Select “ID2” when the remote control TUNER ID code
is set to “5016”.
Setting remote control TUNER ID codes
You need to set the remote control TUNER ID library
code for the remote control.
1 While pressing and holding ® TUNER on the
remote control, press (DAV POWER for
more than 3 seconds.
©AMP flashes twice.
TUNER
While holding
down
♦
POWER
Press for 3
seconds
I AMP I
flashes
Press the numeric buttons (®) to enter the
code number “5007” or “5016”.
When the setting succeeds, ©AMP flashes twice;
however, when it does not, ©AMP flashes
repeatedly.
TUNERID
eod«*1
■', "1
TIMER
5007 To Operate this unit using IDl
(initial setting) the default code. (initial setting)
5016
To operate this unit using
an alternative code.
ID2
The remote control setting
*2 The setting of this unit
i07 En