Yamaha RX-V663 - Manual (Page 89)

Customizing this unit (MANUAL SETUP)
1 BASIC MENU
Use this feature to manually adjust the basic speaker
settings. Most of the “BASIC MENU” parameters are set
automatically when you run the automatic setup.
1 BASIC MENU
^ fi)SPEAKER SET
B>SP LEUEL
OSP DISTANCE
D)TEST TONE
[■*■]/[¥]: IJp/Down
CENTER]: Enter
Set “TEST TONE” to “ON” to output the test tone for the
“SPEAKER SET”, “SP LEVEL” and “SP DISTANCE”.
■ Speaker settings fl> SPEAKER SET
To select the desired parameter, press ®
A
/
V
repeatedly.
Extra speakers assignment EXTRA SP ASSIGN
Selects the function of the speakers connected to the
EXTRA SP terminals.
A>SPEAKER SET
EXTRA SP ASSIGN
Z0NE2 >FR0NT B
ZONE B PRESENCE
NONE
Z0NE2 SET
Not Aualiable
ZONE2 Select this setting when you use the Zone 2
speakers (see page 104).
FRONT B Select this setting when you use another front
speaker system in the main zone (see page 43).
ZONEB Select this setting when you use another front
speaker system in another room (see page 43).
PRESENCE Select this setting when you use the presence
speakers (see page 13).
NONE Select this setting when you do not use the
EXTRA SP terminals.
LFE/bass out LFE/BASS OUT
Use this feature to select the speakers that output the LEE
(low-frequency effect) and the low-frequency signals.
LFE signals output
SuiniRKii^sl «mi speakers '
Choice
Siriiwooiwfts}
Fiwil
speaker«
mm
BOTH Output No output No output
SWFR Output No output No output
FRONT No output Output No output
Low-frequency signals output
«NMi apwriom |
Choice
SvribwoKMNMTfs}
Front
iqMidewns
Otfisr ;
t^fMMriwre i
BOTH *1 *2
*3
SWFR
*4
*3 *3
FRONT No output *1
*3
*1 Output(s) the low-frequency signals of the front
channels and other speakers set to “SMALL”.
*2 Always output the low-frequency signals of the front
channels.
*3 Output the low-frequency signals if the speakers are set
to “LARGE”.
*4 Outputs the low-frequency signals of the speakers set to
“SMALL” or “NONE”.
Notm
• This parameter shares the value with the “EXTRA SP
ASSIGN” parameter in “AUTO SETUP” (see page 33).
• If you select “ON” in “BI-AMP” (see page 109), you cannot
select “PRESENCE” or “ZONE2” in “EXTRA SP ASSIGN”.
• After changing the “EXTRA SP ASSIGN” setting, carry out
“AUTO SETUP” again (see page 32).
85
En