Yamaha FX550 - Manual (Page 38)

Chapter 5: Remote Control
9. Press the [EDIT] button to show the CTRLl display shown above.
-Max.
-Min.
10. Press the [ T ] or [ A ] button to show the parameter that is to be controlled.
11. Press the [ ] or [ ► ] button to position the cursor, and use the [ T ] and [ ▲ ] buttons to
set the min and max control range.
The min and max values are expressed as a percentage (%) of the parameters range. For
example, the variable range of the Distortion effect’s TON parameter is -30 to -i-30. If the
min and max values are set to 20 (%) and 60 (%) respectively, as shown below, the control
range will be -18 to
+6.
12. Press the [EDIT] button to show the CTRL2 display, and repeat steps 10 and 11 to set up the
2nd MIDI Controller.
13. Store the settings and switch to Play mode.
• Operation Procedure
1. Connect the MIDI output of the device that is sending the MIDI Controller to the FX550’s
MIDI IN connector.
2. Transmit the corresponding MIDI Controller to the FX550.
36