Yamaha PSR-310 EN - Manual (Page 24)

MULTI DISPLAY
I_______ I
T To select the Multi mode:
Hold down the REC button and press the NUMERIC SELEC­
TION 0 button.
Each time 0 is pressed while holding down the REC button the PSR -310
switches between the Remote Control mode “rc” and the Multi mode ‘1
□ The foUowing data is transmitted: J The following applies to data received:
e Velocity data
• Sustain ON/OFF data.
• Keyboard performance data
0 Program Change messages (Program change num­
bers 00 through 99 correspond to the PSR-310's voice
numbers 01 U^rough 00)
The following data is not transmitted:
0 ACCOMPANtMENl SONG BOOK, MELODY AND
CHORD MEMORY performances data.
0 Transpose settings
Sustain ON/OFF data (The panel setting will not change)
Program Change messages (with the exception of
channel 16, which is reserved for rhythm data) (Pro­
gram change numbers 00 through 99 correspond to the
PSR-SIO’s voice numbers 01 through 00)
Velocity sensitivity is the same for all voices.
MIDI START, STOP, and Clock messages are not
received.
2 4 7 9 11 14 16
MIDI Channels
MIDI channels allow communication between individual devices in a MIDI system. Before you can communi­
cate with a particular MIDI device you need to match its MIDI channel. A sending device can send messages on ^
any of 16 MIDI channels. Only the receiving MIDI devices that are set to that channel receive the messages. A
MIDI device can also be set to receive MIDI messages on all channels; this is known as the OMNI ON mode.
MIDI Transmission Channel
The PSR-310 can be set to transmit on any of its 16 MIDI channels.
▼ To set the MIDI transmit channel:
1. Hold down the REC button and press the NUMERIC
SELECTION 1 button.
The current MIDI channel will appear on the MULTI DISPLAY.
2. While still holding down the REC button press one of the key­
board keys (C1 through El>2) to select a corresponding MIDI
channel.
The keys Cl through El’2 correspond to MIDI channels 1 through 16.
MIDI Reception Channels
The PSR-310 can be set to receive on any of the 16 MIDI channels or to ALL MIDI channels (OMNI ON).
T To set the MIDI receive channel:
1. Hold down the REC button and press the NUMERIC
SELECTION 2 button.
The current MIDI channel will appear on the MULTI DISPLAY.
2. While still holding down the REC button press one of the key­
board keys (Cl through E2) to select a corresponding MIDI
channel.
The keys Cl through El’2 correspond to MIDI channels 1 through 16, and
key E2 selects ALL (OMNI ON mode).
□ OMNI ON is automatically selected when the PSR-310 is first switf^ted on.
1 3 5 6 3 10 12 13 15
14 16
5 6 8 10 12 1315 ALL
□ If a MIDI message is not transmitted or received due to a
transmission or reception error, no sound will be produced
(MIDI error).
□ If MIDI data is received that exceeds the transmission and
reception buffer capacity, no sound will be produced (Buffer
full).
22