Industrial Injection FORD 6.7L Compound Turbo - Manual (Page 31)

Pg. 31
You will use the orange O-ring gaskets in the bottom of the factory Upper Intake manifold. There are
little tabs that you will need to cut off for the O-rings to fit into the aftermarket Y-bridge.
Drop the Y-bridge into place and thread in the four bolts on the driver’s side flange first. Only thread
them in about 2 or 3 threads.
Then move to the passenger’s side and thread those bolts in a couple of threads. If you are having trou-
ble getting a bolt to thread in you will be able to lift the pipe up and down since the driver’s side bolts
where left loose.