Industrial Injection FORD 6.7L Compound Turbo - Manual (Page 15)

Pg. 15
Using a small crow bar or large flat head screw driver, you will need to bust the plastic tabs holding the
fuel rail shield to the side of the EGR Cooler (this is not re-used so don’t worry about messing it up).
With everything removed you are ready to lift the EGR Cooler out of the engine bay. The EGR Cooler sits
on two 1/4” alignment dowels. You will need to lift up the front and then the back and slide the Cooler
forward until it is out from under the engine cowl and then lift it up and out.