ThingMagic Autonomous Configuration Tool User Manual
Page 21
Read
Autonomous Configuration Tool v1.0 User Guide
21
Timestamp - The timestamp when the tag was last seen during this query.
RSSI -
The receive signal strength of the tag response, in dBm.
ReadCount -
The number of times the tag was read on [Antenna].
In addition to the above fields, additional fields can be displayed using the
settings.
When in GPI Triggered mode and GPI is low a keep-alive message is sent periodically
containing the module temperature. The temperature is displayed at the bottom of the
Read tab.
Note
This read display only works during initial saving of autonomous configuration.
Once the device has been disconnected from ACT it cannot be reconnected to the
Read display screen while in autonomous mode. If adjustments need to be made to
the auto-config behavior you should return to the
steps. Otherwise, at this
point you should start “catching” the data with your own application, see
for details.