ThingMagic Autonomous Configuration Tool - Manual (Page 15)

Configure
Autonomous Configuration Tool v1.0 User Guide 15
Configure
After a successful Connect to a reader the Configure tab, as shown in Figure 3, provides
all the available autonomous reading settings. In addition you can install firmware,
configure the
Read display options and check the current firmware version of the
connected reader.
Figure 3: Configure Tab
W A R N I N G !
Once Apply is clicked all selected settings will be saved to the connected reader.
This may cause the reader to start reading at 100% duty cycle.
Read & Write Settings
This sections allows the basic behavior of a autonomous reading to be defined.
The following configuration settings can be defined for autonomous operation: