Pridiom Solar Series Installation Manual - Manual (Page 6)

5
INSTALLATION INSTRUCTIONS
Fi g.4
Wall
Indoor
Outdoor
F ig.6
Fig.5
Indoor unit installation
2. Drill a hole in the wall
1. Fit the Installation Plate
1. Fit the installation plate horizontally
on structural parts of the wall with
spaces around the installation plate.
2. If the wall is m ade of brick, concrete
or the like, drill eight (8) 5m m diam eter
holes in the wall.Insert Clip anchor for
appropr iate mounting screws.
3. Fit the installation plate on the wall
with eight (8) type “A” screws.
1. Determine hole positions according
to the diagramdetailed in Fig.5. Dr ill
one (1) hole (
65mm) slanting slightly
to outdoor side.
2. Always use wall hole conduit when
drilling metal grid, metal plate or the like.
φ
C orre ct or ient ation
o f Ins talla tion Plat e
Note:
Fit the Installation Plate and drill
holes in the wall according to the
wall structure and corresponding
mounting points on the installation
plate. The installation plate is different
according to the models.
(Dimensions are in “mm” unless
otherwise stated)
900
Right rear side
refrigerant
pipe hole 65 φ
Installation plate
Indoor unit outline
Left rear side
refrigerant
pipe hole
65 φ
150mm or more to ceiling
120mm or
more to wall
120mm or
more to wall
9 0 150
PDF created with pdfFactory Pro trial version www.pdffactory.com