Pridiom Solar Series Installation Manual - Manual (Page 19)

6. General installation
Module mounting must use the pre-drilled mounting holes in the frame.
The most common mounting is achieved by mounting the module using the four symmetry
points closed to the inner side on the module frame.
If excessive wind or snow loads are expected, all eight mounting holes must be used.
If you want to install the module without using the
Do not attempt to lift the module by grasping the module s junction box while moving.
Do not stand or step on module.
Do not throw the module or drop any thing on the module.
To avoid galss breakage, do not place any heavy objects on the module.
Do not set the module down hard on any surface.
Inappropriate transport and installation may break the glass of the module.
pre-drilled mounting holes in the frame, please
consult with the supplier.
Do not install in the rainy weather, it may cause insulation failure due to moisture, and there is
a risk of electric shock.
,
18
ELECTRICAL WORK
Fig.47
Fig.48
F ig.49
Fig.50
Fig.51
PDF created with pdfFactory Pro trial version www.pdffactory.com