Pridiom Solar Series Installation Manual User Manual
Page 14
When disconnecting wires from a photovoltaic module that is exposed to sunlight,
an electric arc may result. Such arcs may cause burns, combustion and may otherwise create
problems. Therefore, be extremely careful!
Photovoltaic solar modules convert light energy to direct-current electrical energy. They are
designed for outdoor use. Modules may be ground mounted, mounted on rooftops, vehicles,
or boats. Proper design of support structures is the responsibility of the system designer and
installer. Proper use of mounting holes is suggested in a following paragraph.
Do not attempt to diassemble the module, and do not remove any attached nameplates or
components.
Do not apply paint or adhesive to module top surface.
Do not use mirrors or other magnifiers to artificially concentrate sunlight on the module.
When installing the system, abide with all local, regional and national statutory regulations.
Obtain a building permit where necessary. Abide with any local and national regulations when
mounting on vehicles or boats.
When installing the solar modules or repairing the air conditioner, ensure the circuit breaker on the
solar panel of the outdoor unit is in the OFF state(push the switch to
position). During
normal operation, the circuit breaker should be in the
state(push the switch to
position) .
"
"
"
"
"
"
"
"
OFF
ON
ON
12
Fig.3 0
Fig.31
Fig .32
13
ELECTRICAL WORK
Safety precaution for install ing a solar photovoltaic system
PDF created with pdfFactory Pro trial versi