Hollywood Racks 45815 Sunlight Recumbent Rack User Manual
Page 8
The SUNLITE recumbent hitch rack is distributed by J&B Importers, Miami FL
Warranty:
This rack is warranted for a period of one year against defects in materials and workmanship, effective from the
date of purchase to the original purchaser. The manufacturer will repair or replace any defective parts due to
materials or workmanship. The manufacturer of this product shall not extend the warranty to: 1.) Any failure or
malfunction of the product do to any of or modifications to the product; or 2.) Damages not attributable to a
defect in materials or workmanship; or 3.) Damages resulting from improper installation on vehicle or attachment
of bicycles on rack. Consequential or Incidental Damages: The manufacturer shall not be liable for any
consequential or incidental damages in connection with the purchase, use or handling of this bike rack.
Purchaser’s Rights: Some states do not allow the exclusion or limitation of consequential or incidental
damages and the above limitation may not apply to you. This warranty gives you specific legal rights and you
have other rights, which vary from state to state.
Made For SUNLITE by Hollywood Racks
For all customer service and warranty questions,
please contact Hollywood Racks directly
12812 S. Spring St. Los Angeles, CA 90061
Tel (310) 516-8600 (800) 747-4085 FAX (310)516-8955
www.hollywoodracks.com email:
Customer Service Hours: M-F 8:00AM to 3:00 PM PST
Made in Taiwan Nov-08 Rev C
8
Double check before driving off:
Knobs are tight on all wheel trays and frame hooks
All retaining pins are properly inserted and secure
Wheel straps are fastened
Hitch pin is secure and hitch pin clip is installed
Extra strap or flag installed if necessary
Drive slowly on bumpy or dirt roads
L. Fold Together Feature
For on-vehicle storage when using
The trike adapter, fold the rack together in
the same procedure as
Described in section 5, fig. 10:
The rack’s wheel support tubes can be
rotated to the side as an alternative way of
folding up the racks. Simply remove pins,
rotate the wheel tube so it is pointing
upwards, align holes and re-insert the pin.