Hollywood Racks 45815 Sunlight Recumbent Rack - Manual (Page 2)

Assembly Instructions:
Tools Required: Two 8” adjustable
wrenches or equivalent, Phillips
screwdriver.
For ease of assembly, we suggest
that you use your vehicle’s hitch.
1: Assemble Receiver Tube
to Base Assembly
1. Install your receiver tube P
into the hitch. Insert hitch pin
Q through hole in the hitch and the
slot in the rack. Put clip R on hitch
pin Q. Then tighten the lever H7
on the front of the insert tube so the
insert tube will not move during
assembly.
2. See Fig. 5 and 6: Gently insert
Base Assy B into the bracket of
Receiver tube H, aligning holes H3
with B2. The main beam can rest
on pin H5. There are two plastic
washers (B3) attached to
main beam B, please take care not
to accidentally knock them off
during assembly. Insert bolt G with
washer J through holes, then place
the other washer J on end of the
bolt and hand tighten nut I.
3. Insert pin H6 through holes H4
and B4.Then install clip R through
the pin. The main beam will now be
in a fixed Horizontal position.
Tighten bolt G and nut I securely
with wrenches
.
4. After tightening, remove clip R &
Pin H6 and rotate Main Beam B
into a folded (vertical) position.
Insert pin H6 through holes H2 and
B1 to check alignment. Main beam
should be able to rotate easily, but
not be too loose.
5. Remove pin H6 and rotate main
beam back to it’s horizontal
position to continue assembly.
Fig. 6
Fig. 5
2: Install frame hooks:
Slide long frame hook down
vertical post facing vehicle.
Then slide short frame hook
onto post, facing away from
vehicle. You should hear be
able to hear the spring loaded
lever engaging the teeth on the
post as shown in fig. 7
To release the frame hook,
depress the Lever and pull the
hook up. Tip: you may have to
push the hook down a bit while
holding in the lever to release
it.
Fig. 7
2