Hollywood Racks 45815 Sunlight Recumbent Rack User Manual
Page 3
3: Install Wheel Holders:
See Fig. 8: Rotate and remove L pins
From holes A. Rotate wheel tubes to a
horizontal position, then replace L pins
into holes B.
Slide wheel Holders E and F onto wheel
tubes as indicated below. See fig. 9
Fig. 8
Fig. 9
4: Fold up feature:
To fold up the main beam,
You must first fold down the
vertical post. Refer to Fig. 10:
Rotate and remove pin A, then
rotate the post (B) and replace
the pin in either holes C.
Now refer to Fig. 10a: remove
clip R from pin H6, then remove
pin H6. Rotate main beam
upward and re-install pin and
clip.
3
5: Fold Together Feature
(shown on right)
The rack’s wheel support tubes
can be rotated to the side as an
alternative way of folding up the
rack. Referring, remove pin from
hole D and rotate the wheel tube
so it is pointing upwards, align
holes E and re-insert the pin.
Repeat for other side.
D
E
Fig. 10
Fig. 10a