beautypg.com

Hollywood Racks Boomer User Manual

Instruction sheet for boomer hitch racks

background image

Locking Hitch
Pin with keys.

Locking knob

Instruction Sheet for Boomer Hitch Racks

Note: Do not use this rack on a trailer, or a vehicle being towed behind another vehicle.
Trailer use voids Warranty. Be sure to read the instructions carefully and completely
before assembling and using your new Boomer rack.

Congratulations on your purchase of the Boomer trailer hitch rack. This instruction sheet is applicable to
the Boomer 2 (for 1-

1/4” or 2” receivers) and the Boomer 4 (for 2” receivers only). Before beginning

assembly, please check the parts list below against the parts included in the box. Please note the
differences between quantities of some parts for Boomer 2 and Boomer 4 applications. Please read the
instructions carefully for proper assembly installation and use of your new Boomer rack.

Boomer Parts List

A. Main Beam
A.

Insert tube with “No Wobble”® feature

B. Locking Top Plate assembly: (one plate for
Boomer 2, two plates for Boomer 4) with keys
C. Lower support arm assembly
D.

86” straps for anti-sway bar (three straps

for Boomer 2, five straps for Boomer 4)
E. Locking Hitch Pin with two keys
F. Lynch Pin and clip
G. 1 - ½” x 3-1/4” bolt with self locking nut

H. 2 - ½” x 1-3/4” SAE washer
I.

Black end cap with reflector

For 4 Bike Hitch Rack, the following is included:
J. 2 bike extension with locking top plate
K. Bolt, nut, washer

Assembly Instructions:
1. Place the main beam into insert tube, making sure
the two holes align. Slide the first washer on to the
3-

1/4” bolt and place through the lower hole of the

main beam and insert tube. After inserting bolt
completely through, place the second washer on the
end of the bolt and tighten securely with the locking nut.

2. Insert the lynch pin in the upper hole of the insert tube

and the main beam. Install lynch pin clip in the hole in
the end of the lynch pin to prevent the lynch pin from
falling out while rack is in use.

3. Install black end cap (with reflector) on rack

Main Beam with

Locking Top Plate

Assembly

Installed.

(Boomer 2 shown)

Locking
top plate
assembly

Boomer 4 bike hitch rack

Boomer 2 bike
hitch rack