Hollywood Racks 45815 Sunlight Recumbent Rack - Manual (Page 4)

6: Tilt –Down Feature:
For easy access to the rear cargo door of your vehicle, the rack can
be tilted down: First fold down vertical post as described earlier.
Next refer to Fig. 10a: Remove pin H5 from receiver tube bracket
and gently lower the main beam down so it is resting on the welded
stop.
4
7: Using the ‘Flat Hook”
For some types of bikes, recumbents and 3 wheelers, the standard
curved hook may not fit as conveniently as the “flat hook”. To replace
the curved hook for the flat hook: Remove the two side bolts as
indicated by the arrows in fig 11 using a 4mm Allen key (not provided).
Slide out the curved hook, and then install the flat hook. Reinstall and
tighten both bolts. See Fig. 11
8: Small Wheel Adapter
For bikes with 16” wheels, use the “small wheel” adapter
to prevent the wheel from falling through the wheel
holder. Place the upper section on top of the wheel
holder, then position the bottom section directly below it.
Insert the bolts and lightly tighten using the included 5mm
hex wrench. Slide the wheel adapter to the desired
position then tighten all 4 bolts securely. See Fig. 12
Fig. 11
Set-up for one bike using flat hook
and small wheel adapter
Fig. 12