ADS Environmental Services Eureka Digital QR 775020 A0 - Manual (Page 20)

ADS Eureka Digital System User Manual
16
Car Charge Cable
The car charge cable can be used to connect the case to a power supply in
a vehicle to recharge the two transmitters in the case. The cable connects
to a socket on the side of the case. The transmitters in the case must be
connected to the two charge cables in the case.
Mains Charger
The mains charge cable can be used to connect the case to an AC power
supply to recharge the two transmitters in the case. The cable connects to
a socket on the side of the case. The transmitters in the case must be
connected to the two charge cables in the case.
Transmitter Y-Cable
This cable is used to connect the receiver to the two transmitters when
programming the transmitters from a PC to record sound, instead of
transmitting sound. This can be used for recording sound after a certain
delay.
Receiver USB Cable
This cable powers the receiver and allows for the transfer of data to and
from the PC. The receiver must receive power from a USB connection to
function.
Transport Case
The transport case stores the standard equipment and provides protection
from the environment. This case can be connected to a car or mains power
source via an adaptor to charge the transmitters when they are stored in the
case. This option can be particularly useful when transporting the system
to a remote location.
Software CD
This CD contains the Eureka Digital software for loading onto a suitable
PC. Refer to Hardware and Software Setup on page 20 in Chapter 4,
Getting Started, for more information.