Wheatheart R Series Augers - Manual (Page 24)

5. O PERATION W HEATHEART - R S ERIES A UGERS
5.4. O PERATING P ROCEDURES R8-36, R8-41, R8-46, R8-51, R10-36, R10-41, & R10-51
24 30758 R1
locked position during shutdown or whenever maintenance is performed on
the auger.
2. If reset is required, disconnect all power before resetting motor.
PTO D RIVELINE
DRIVE SYSTEM
1. Ensure that the PTO driveline is securely attached to the tractor and
jackshaft.
2. Do not use PTO driveline without a rotating shield in good working order.
3. Do not exceed the maximum operating angle of 15°
4. Be sure that the PTO-drive on the tractor is in the off position before starting
tractor.
5. Stay clear of the PTO hazard area.
LOCKOUT
1. Shut off engine.
2. Remove ignition key from tractor.
3. If step 2 is impossible, remove the PTO driveline from tractor.
5.4. OPERATING PROCEDURES
5.4.1. B REAK - IN P ERIOD
Your auger does not require an elaborate break-in. However, following a few
simple tips during the first 1000 bu of operation can add to the reliability and life
of your machine.
If any unusual noises or vibrations are encountered, determine the source, shut
the auger off, lock out the power source, and adjust. If unsure of the problem, or
the procedure to fix it, contact your local Wheatheart dealer.
P RE O PERATION C HECKLIST :
• Read the power source operation manual.
• Inspect motor mounting bolts for tightness.
• Check oil level in the gear box by removing the filler plug. Make sure the
gear box is half full (center cross shaft) and free of foreign objects.
• Inspect all belts for alignment, tightness, and abnormal wear. Adjust or
replace as required.
• Inspect components for damage and abnormal wear. Replace as
required.
• Check that safety decals are installed and legible. Apply new decals if
required.
• Check the wheel bolt torque prior to transporting the unit. See Section
6.3.6. for recommended torque values.
• Check that tires are inflated to the manufacturer’s recommended pressure
prior to transporting the unit.