NTi Audio Minirator MR-PRO - Manual (Page 27)

27
Sweep Signal modes
Using the “MODE” symbol, you can run the test signal in the
following modes:
Once-only Plays the test signal once
Continuous Repeats the test signal after an adjustable
pause (tPAUSE).
Parameters
Output level
The frequency display is for information only. The
current frequencies will be displayed here once the
SWEEP test signal has been started.
You can configure the signal sequence here.
Test Signals
B
t
t
TRIG
t
STEP
f
RES
A
ff
f
t
STEP
t
STEP
t
STEP
f
STOP
f
START
1 kHz
A The sweep recording starts as soon as the frequency
drops from 1 kHz to fSTART.
B The end of the sweep will be signaled by a falling fre-
quency.