Brother HL-1260 - Manual (Page 161)

VI - 9
7. STATUS MESSAGE LIST
The paper cassette (XX is
MP/T1/T2) is out of paper.
The upper cover of the
printer is open.
Paper is jammed in the
printer. XXXXXX is TRAYS/
INSIDE/REAR/DUPLEX.
The toner cartridge is not
installed in the printer.
The paper cassette is not
installed. XX is T1/T2.
The printer has almost run
out of toner: you may print
another 30 to 100 pages.
(The ALARM lamp lights at
the same time.)
The wrong size of paper was
loaded in the paper cassette
XX. XX is MP/ T1/T2. (The
message appears alternately
to show a particular size.)
The printer requests you to
load paper manually. (The
message appears alternately
to show a particular size.)
An error occurred in the
optional font cartridge/card.
The font cartridge/card was
removed while the printer is
on-line.
The duplex unit is not
installed with the printer
when the duplex printing
mode is selected.
The duplex paper guide tray
is not installed in T1 when
the duplex printing mode is
selected.
The cover of the duplex unit
is open.
Operator Call Message
CHECK XX TRAY
12 COVER OPEN
13 JAM XXXXXX
14 NO CARTRIDGE
XX NO CASSETTE
16 TONER EMPTY
XX LOAD PAPER *****
SIZE
18 MANUAL FEED *****
SIZE
19 CHECK FONT
20 FONT REMOVAL
27 NO DX UNIT
27 NO DX TRAY
27 DX OPEN
Meaning
Load a stack of paper into
the cassette. See M-7.
Close the cover. See M-6.
Remove the jammed paper
from the indicated area. See
M-10.
Install a toner cartridge. See
M-8.
Install the paper cassette.
Remove the toner cartridge,
rock it several times at 45°,
and install it again. Or
replace the toner cartridge
with a new one. See M-9.
Load the requested size of
paper in the paper cassette,
or load it on the manual feed
tray and press the FORM
FEED switch.
Load the requested size of
paper on the multi-purpose
tray and press the SEL
switch.
Turn off the printer, and
reinstall or replace the
optional font cartridge/card.
Turn off the printer, install
the font cartridge/card, and
turn on the printer. The
CONTINUE switch will allow
you to temporarily ignore this
message.
Install the duplex unit
correctly.See the DX-1200
/DX-1600 user’s guides.
Install the duplex paper guide
tray into T1. See the DX-1200
/DX-1600 user’s guides.
Close the cover. See the DX-
1200/DX-1600 user’s
guides.
Action
Table 6.1 Operator Call Messages