Hale ESP Priming System - Manual (Page 8)

❑ Safety
8 ESP Primer System Instruction Guide
p/n: 029-0810-01-0
NOTICE !
NOTICE - Practices which could result in damage to the apparatus or other
property.
1.2 GUIDELINES
NOTICE !
THE PROCEDURES IN THIS MANUAL ARE GENERAL OPERATING PROCE-
DURES. THEY DO NOT REPLACE THE PROCEDURES, POLICIES OR GUIDE-
LINES ESTABLISHED BY THE AUTHORITY HAVING JURISDICTION, NOR DO
THEY REPLACE THE RECOMMENDATIONS AND PROCEDURES PROVIDED IN
THE APPARATUS MANUFACTURER'S MANUAL.
REFER TO THE PROCEDURES PROVIDED BY THE AUTHORITY HAVING JURIS-
DICTION ON SETTING WHEEL CHOCKS (TO PREVENT ANY MOVEMENT OF THE
APPARATUS), AS WELL AS LAYOUT AND CONNECTION OF HOSES, VALVES
AND DRAIN COCKS.
❑ Use care when removing the primer system, including SPV and PVG valves,
from its packaging to prevent personal injury and/or damage to the
components.
❑ Use all mounting bolt holes provided on the primer to support the assembly.
See the appropriate plate drawing, located at the back of this manual, for
additional installation information.
❑ Installation should be performed by a trained and qualified installer, such as
your authorized service representative. Be sure the installer has sufficient
knowledge, experience and the proper tools before attempting any installa-
tion.
❑ The installer is responsible for observing all instructions and safety precau-
tions in his or her daily routine as dictated by regional safety ordinances or
departmental procedures.
CAUTION !
ALL FASTENERS USED HAVE BEEN SELECTED FOR THEIR APPLICATION.
HALE PRODUCTS DOES NOT RECOMMEND REPLACING FASTENERS WITH
ANYTHING OTHER THAN HALE PART NUMBERS PROVIDED. REPLACING WITH
A WEAKER ALTERNATIVE POSES A SERIOUS SAFETY RISK.
ALL FASTENERS MUST BE INSTALLED WITH A LOCKING ANAEROBIC ADHE-
SIVE/SEALANT, SUCH AS LOCTITE
® #246.